Date:2026-11-20 08:27:30
Researchers led by Xi’an Jiaotong University in China have developed a 3D printable hydrogel for bone scaffolds whose fracture toughness could be set anywhere from 8.5 to 200.5 MJ/m³ by changing the molecular weight of polyethylene glycol (PEG) chains in the material.
The study, published in Frontiers in Bioengineering and Biotechnology, targeted the brittleness of poly(propylene fumarate) diacrylate (PPF-DA), a degradable polymer studied for bone tissue engineering.
The authors found that PPF-DA made through conventional crosslinking was brittle and prone to irreversible fracture under cyclic physiological loading, restricting its use in load-bearing bone defects with complex shapes.
The team copolymerized PPF-DA with 2-hydroxyethyl methacrylate (HEMA) to form a dense crosslinked framework, then introduced PEG with progressively greater molecular weights. The PEG chains interpenetrated and entangled within the network. Across formulations, Young’s modulus ranged from 0.5 to 50 MPa and the degradation ratio from 53% to 72%.
Performance peaked with 1,000 Da PEG, which reached a maximum stress of about 40 MPa, more than 40 times that of the 200 Da group, with 300% elongation at break and toughness of about 200.5 MJ/m³. The 200–400 Da formulations stretched up to 580% but held only about 0.9 MPa. Moving to 1,500 Da dropped the modulus to about 4.8 MPa, which the authors attributed to microphase separation and lower crosslinking density.
Using a commercial Anycubic Photon Mono 2 DLP printer, the team printed porous grid scaffolds, a 2 cm porous sphere and a 4 cm cubic lattice with interconnected millimeter-scale channels. Printed pores could exceed 500 µm, alongside intrinsic micropores averaging 2.54 µm.
The scaffolds carried the antibiotic ciprofloxacin. Mixed in physically, the drug largely released within 24 hours and bonded covalently to the PEG chains, with release lasting about two months. Drug-loaded samples produced inhibition zones against Escherichia coli and Staphylococcus aureus, and showed no cytotoxic effect on L929 mouse fibroblast cells.
The authors described the system as the first toughened, high-precision 3D printable modified PPF material.